Your Trees Get Thirsty Too!

Immediately after planting, all tree roots are in the original root ball or container area. Until new roots grow out & into the surrounding soil, water the original root ball area and just beyond. This area may dry out faster than the surrounding soil, so check the moisture in this area frequently for the first 1-2 months after planting. Overhead spray irrigation systems and natural rain falls are usually insufficient to thoroughly wet them.  Water must be directed on the transplanted root ball and applied slowly for absorption.

Proper care and watering of trees

New trees need approximately 15 to 20 gallons of water at the time of planting, depending on how dry the soil is. Water twice a week for the first 2 weeks and once a week thereafter.  Stop if 2 inches or more of rain falls within a day or two.  Resume watering one week after rain stops.  Continue to water in early spring, late fall or even winter when temperatures are over 50 degrees and breezy.  If in doubt feel the root ball.

How trees absorb water

Watering is best accomplished by hand with a hose, bucket or setting up an irrigation system with specific emitters applying water directly around the stem for each individual plant. There are a variety of watering “bags” available that usually hold 20 gallons of water, and work great during hot summer months.

When using a hose, turn down the water pressure or force to 25% or fill a 5 gallon bucket with water after it is drilled with four 1/4 inch holes, one inch apart on one side and place next to the stem.

For shade, flowering and evergreen trees 8 to 15 feet in height, apply 10 gallons slowly.  Using a 5/8″ hose with an average of 40 pounds of water pressure it takes about 4 minutes to generate 10 gallons.  At 25% force or 10 pounds pressure it will take 12 minutes for each plant.

For shrubs and evergreens 2 to 6 feet in height apply 5 gallons slowly.  At 25% force or 10 pounds pressure it will take 6 minutes for each plant.

For a few annuals, perennials and ground covers apply 1 gallon slowly.  At 25% force or 10 pounds pressure it will take 1 minute per plant.  Since plants are small, water will saturate surrounding soil and keep plants from drying out quickly.  For many plants, use an overhead sprinkler or automatic irrigation system.  Apply 1 inch of water uniformly over the entire planting bed.  At 40 pounds pressure it will take 30 minutes for each area.


Watering and care of established trees

In summer, most people water their lawns, but often forget their trees!  A good, lush green lawn may require more frequent watering than established trees and shrubs, but it is possible to properly water your lawn while at the same time not meeting a tree’s needs.

It is recommended that established trees and shrubs get 1″ of water over their root zone every 7-10 days.  Natural rainfall may accomplish this on occasion, but our typical summer doesn’t provide adequate amounts of rain all the time.

Slow soaking is best, reducing wasteful runoff and evaporation loss.  An accurate way of measuring how much water you have applied is to place a sprinkler in the areas you wish to water and then place a container(s) with straight sides—such as a coffee mug, metal can, or plastic container – within the coverage area of the sprinkler. Then, turn the water on until 1″ of water has accumulated in the container, using a ruler to measure the depth of the water.

Be sure to cover as much of the area beneath the branch spread of the tree as possible.